A.1. Command Line Syntax

To obtain a quick reference, run:

# prptHTTPBX -h

It prints out:

usage: prptHTTPBX [-hv] [-c <file.cfg>] [-l] [[address:]port]

The meaning of each argument is described in the following table:

option note


Prints out the command line syntax, as shown above.


Prints out the software version.

-c <file.cfg>

Specifies a non-default configuration file.


Forces the connector to start in remote mode, listening for server connections on the TCP interface and port specified by [[address:]port] or, if these are unspecified, defaulting to what is defined in the configuration file in the [network] section.

If the -l option is omitted, the connector will initiate a TCP connection towards the server as specified by [[address:]port], again, defaulting to the definitions in the [network] section of the configuration file.